Policies

School Work Equipment Defect, Isolation and Safe-Use Procedure

To provide a consistent procedure for inspecting work equipment, reporting deterioration or defects, withdrawing dangerous equipment from use, applying safe temporary controls where appropriate, arranging competent assessment or repair, and confirming that safety concerns have been addressed before return to service at {{school_name}}.

SOP Template
CalmComplianceSOP Template

School Work Equipment Defect, Isolation and Safe-Use Procedure

Version
v2
Updated
7 October 2026

Fields in brackets are completed when you adapt this template.

This procedure applies to maintained and academy primary and secondary schools in England where work equipment, powered gates, barriers or doors are used or controlled. The powered-gate controls apply where a gate is suspected or confirmed to be unsafe.

Responsibilities

[equipment responsible role] is responsible for coordinating inspection, defect reporting, withdrawal from use, temporary controls, assessment or repair, and return-to-service decisions under this procedure.

Where a powered gate is suspected or confirmed to be unsafe, [competent person role] must be engaged to assess or make the gate safe before normal operation resumes.

Inspection and maintenance

[school name] must arrange regular inspection and maintenance of work equipment so that it remains safe. Particular attention must be given to equipment whose safety depends on installation conditions or equipment exposed to conditions that could cause dangerous deterioration.

Inspections must identify whether equipment can be operated, adjusted and maintained safely. Any deterioration or defect that could create a health or safety risk must be reported promptly to [equipment responsible role].

Defect and dangerous-condition response

When a defect, deterioration or dangerous condition is identified, stop using the affected equipment where continued use could create a safety risk and notify [equipment responsible role].

Equipment found to be dangerous must be taken out of use immediately and kept out of use until the safety concerns have been adequately addressed.

Apply suitable isolation or other temporary controls to prevent unsafe use while the equipment remains out of service. The defect, the action taken and the status of the equipment must be recorded.

Powered gates, barriers and doors

If a powered gate is thought to be unsafe, arrange for [competent person role] to make it safe, including installing safety mechanisms or protective devices where appropriate.

Until the powered gate has been made safe, switch it off or restrict its use to a safe supervised mode, such as direct hold-to-run control.

A powered gate, barrier or door that is found to be dangerous must remain out of use until all safety concerns have been adequately addressed.

Assessment, repair and return to service

Arrange competent assessment or repair for the affected equipment where required. Retain the defect report, the temporary control or isolation details, and the assessment, repair or corrective-action record.

Do not return equipment to normal use until the relevant safety concerns have been adequately addressed. For a powered gate, normal operation must resume only after the gate has been made safe and this has been confirmed by [competent person role].

Sources

  1. Equipment and machinery frequently asked questions (FAQs) - HSEHealth and Safety Executive (HSE)
CalmCompliance · v2Template for adaptation

Template details

Type
SOP Template
Version
v2
Updated
7 October 2026
Sections
19 sections
  • Equipment and machinery frequently asked questions (FAQs) - HSE

Get this template

Free, editable Word document. We’ll email you a download link. No Calm account needed.

Edit in Word or Google Docs.

We record your email and the template you request. Read our privacy policy.