School Powered Gate and Dangerous Work Equipment Isolation Procedure
- Version
- v2
- Updated
- 7 October 2026
This procedure applies where the school has powered gates, barriers, doors or other work equipment and a dangerous condition or suspected safety defect is identified.
Immediate action
When a powered gate or other work equipment is found to be dangerous, take it out of use immediately. Keep it out of use until the safety concerns have been adequately addressed.
For a powered gate, switch it off. Until it has been made safe, it may only be used in a safe, supervised mode such as under direct hold-to-run control.
Competent-person assessment and repair
Arrange for a competent person to make the equipment safe. This may include installing safety mechanisms or protective devices, where required.
Normal operation must not resume until the gate or other work equipment has been made safe and the identified safety concerns have been adequately addressed.
Return to service
Keep the equipment isolated or restricted to safe supervised use until the competent person has addressed the safety defect or dangerous condition. Return the equipment to normal operation only after it has been made safe.
Sources
- Equipment and machinery frequently asked questions (FAQs) - HSEHealth and Safety Executive (HSE)