School MEWP daily and operational checks
- Version
- v2
- Updated
- 7 October 2026
- Who this checklist is for
- Maintained and academy primary and secondary schools in England, where a MEWP operates on school-controlled grounds or other applicable areas. Not intended for independent schools.
- Jurisdiction
- england
14 checklist steps
Blank response areas · preview only
Identify the MEWP
Response required
Record the MEWP identification or fleet reference before starting the checks.
MEWP identification or fleet reference
Use the manufacturer's instructions
Review the manufacturer's instructions and carry out the daily visual and pre-use checks required for this particular MEWP.
Complete the daily visual check
Complete the daily visual check before using the MEWP.
- Yes
- No
- Not applicable
Notes
Check inspection and servicing status
Check the available inspection and servicing information against the manufacturer's instructions and the risks associated with this MEWP.
- Yes
- No
- Not applicable
Notes
Record identified defects
Response required
Record any defect or problem identified during the checks.
Enter 'None identified' or describe each defect or problem
Report defects or problems
Report identified defects or problems through the applicable site or equipment reporting process.
- Yes
- No
- Not applicable
Notes
Quarantine safety-critical defects
If a defect is safety critical, stop using the MEWP and remove it from service until the applicable defect-control process has been followed.
- Yes
- No
- Not applicable
Notes
Check ground firmness and level
Before positioning or using the MEWP, confirm that the intended operating area is firm and level.
- Yes
- No
- Not applicable
Notes
Check temporary covers
Where temporary covers are present, confirm that they are strong enough to withstand the pressure applied by the MEWP.
- Yes
- No
- Not applicable
Notes
Check localised ground features
Check the operating area for trenches, manholes, uncompacted backfill and other localised ground features that could affect stability.
- Yes
- No
- Not applicable
Notes
Use the MEWP only where ground conditions are suitable
If the ground, temporary covers or localised ground features are not suitable for the MEWP, do not proceed until the applicable site controls have been addressed.
- Yes
- No
- Not applicable
Notes
Extend and chock outriggers
Where the MEWP has outriggers, extend and chock them before raising the platform.
- Yes
- No
- Not applicable
Notes
Use spreader plates where required
Where the equipment manual requires spreader plates, install and use them before operating the MEWP.
- Yes
- No
- Not applicable
Notes
Record the check outcome
Select the current outcome for this MEWP after completing the applicable checks.
Choose one
- No defect identified and applicable checks completed
- Defect or problem identified and reported
- Safety-critical defect identified and MEWP removed from service
- Ground or setup condition not suitable for operation