School Lifting Equipment Safe Working Load and Marking Checklist
- Version
- v2
- Updated
- 7 October 2026
- Who this checklist is for
- Maintained and academy primary and secondary schools in England that use or control lifting equipment or lifting accessories.
- Jurisdiction
- england
10 checklist steps
Blank response areas · preview only
Applicability
Use this checklist where the school uses or controls lifting machinery or lifting accessories, such as hoists, lifting accessories or other machinery for lifting loads.
Equipment or accessory identification
Response required
Record the equipment or accessory identifier, location and type before checking its marking or safe working load information.
Identifier, location and type
Safe working load information
Check whether the lifting machinery or accessory is clearly marked, or is provided with information, indicating its safe working load.
Choose one
- Clearly marked
- Information provided with the equipment
- Missing
- Illegible
- Not applicable to this equipment or accessory
Configuration-specific capacity
Where the safe working load depends on the configuration of the lifting machinery, check that the safe working load is shown for each configuration or that the relevant configuration information is kept with the machinery.
Choose one
- Safe working load does not vary by configuration
- Safe working load is marked for each configuration
- Configuration information is kept with the machinery
- Configuration-specific information is missing
- Configuration-specific information is illegible
Chain and wire sling marking
If the item is a chain or wire sling, check whether the safe working load is marked legibly and indelibly on a durable attached tag or label, or on the ferrule or master link.
Choose one
- Not a chain or wire sling
- Legible and indelible marking on a durable attached tag or label
- Legible and indelible marking on the ferrule or master link
- Missing
- Illegible or not indelible
Alternative indication of safe working criteria
Response required
Where a marking cannot show the safe working load, record the alternative method used to indicate the safe working criteria, such as an equipment capacity indicator or information kept with the equipment.
Alternative indication, or state that this does not apply
Colour coding
If colour coding is used to indicate safe working load, record whether another safe working load marking or indication is also available; colour coding alone is not normally acceptable.
Choose one
- Colour coding is not used
- Colour coding is additional to another marking or indication
- Colour coding is the only indication
- Unable to determine
Integrated lifting accessories
If an individual lifting accessory forms part of a specific item of lifting equipment, remains assembled with it and is not disassembled after use, record this arrangement and check that the lifting equipment is marked with a safe working load suitable for all items in the assembly.
Choose one
- Accessory is not an integrated part of a specific item
- Assembly has a safe working load suitable for all items
- Assembly safe working load is missing
- Assembly safe working load is illegible
- Assembly arrangement or suitability is unclear
Marking condition
Check the condition of the marking or safe working load information and record any damage, fading, detachment, correction or other change affecting the information.
Choose one
- Legible and unchanged
- Corrected
- Damaged
- Faded
- Detached
- Other change affecting the information
Defect or correction record
Response required
For any missing, illegible, damaged, detached, corrected or otherwise changed marking or information, record the exact issue, the affected equipment or accessory and the action taken or required. If none applies, state that no issue was identified.
Issue and action, or state that no issue was identified